B1BC7
B1BC7-DEPLOYMENT DATA RECORD FULL
Theory of Operation
When powered, the Occupant Restraint Controller (ORC) performs an internal self test. The repair of this fault condition does not involve any
external circuitry and centers on verifying the integrity of the module's internal memory.
- When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.
- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 71
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. See: Restraints and Safety Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Restraints System Pre-Diagnostic Procedure.
1. CHECK FOR ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.
Is the Deployment Data Record Full DTC active?
Yes
- Go To 2
No
- Perform the ORC VERIFICATION TEST. See: Verification Tests/Occupant Restraint Controller (ORC) Verification Test.
2. REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these
instructions may result in possible serious or fatal injury.
WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in
accidental airbag deployment and serious or fatal injury.
Repair
- Replace the Occupant Restraint Controller.
- Perform the ORC VERIFICATION TEST. See: Verification Tests/Occupant Restraint Controller (ORC) Verification Test.
B1BC7-DEPLOYMENT DATA RECORD FULL
Theory of Operation
When powered, the Occupant Restraint Controller (ORC) performs an internal self test. The repair of this fault condition does not involve any
external circuitry and centers on verifying the integrity of the module's internal memory.
- When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.
- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 71
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. See: Restraints and Safety Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Restraints System Pre-Diagnostic Procedure.
1. CHECK FOR ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.
Is the Deployment Data Record Full DTC active?
Yes
- Go To 2
No
- Perform the ORC VERIFICATION TEST. See: Verification Tests/Occupant Restraint Controller (ORC) Verification Test.
2. REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these
instructions may result in possible serious or fatal injury.
WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in
accidental airbag deployment and serious or fatal injury.
Repair
- Replace the Occupant Restraint Controller.
- Perform the ORC VERIFICATION TEST. See: Verification Tests/Occupant Restraint Controller (ORC) Verification Test.
