B1D6E
B1D6E-SEAT HORIZONTAL POSITION SENSOR CIRCUIT HIGH
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 313
- When Monitored:
When the seat motor is activated (sensor supply voltage is switched on whenever motor is activated).
- Set Condition:
If during motor operation the sensor voltage is not within a specified range this code will set. This DTC will only set when the seat switch is
moved in the same direction three consecutive times.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 314
1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. Using the scan tool, record and erase DTCs
3. Move the seat switch in the horizontal position three times.
4. Using the scan tool, read DTCs.
Does the scan tool display B1D6E-SEAT HORIZONTAL POSITION SENSOR CIRCUIT HIGH?
Yes
- Go To 2
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors.
- Perform the POWER SEAT SYSTEM VERIFICATION TEST. See: Verification Tests/Power Seat System Verification Test.
2. CHECK THE (G401) DRIVER SEAT HORIZONTAL POSITION SENSE VOLTAGE
1. Disconnect the Driver Horizontal Seat Adjuster Motor.
NOTE: Check connectors - Clean and repair as necessary.
2. With the scan tool erase DTCs
3. Move the seat switch in the horizontal positions three times.
4. Using the scan tool, read DTCs.
Does the same DTC reset?
Yes
- Inspect the position sense wire for a possible short to voltage from another circuit, if OK replace the Memory Seat Module.
- Perform the POWER SEAT SYSTEM VERIFICATION TEST. See: Verification Tests/Power Seat System Verification Test.
No
- Inspect the position sense wire for a possible intermittent short to voltage from another circuit, if OK replace the Driver Horizontal Seat
Adjuster Motor assembly.
- Perform the POWER SEAT SYSTEM VERIFICATION TEST. See: Verification Tests/Power Seat System Verification Test.
