B1D5D
B1D5D-ADJUSTABLE PEDAL SWITCH CIRCUIT STUCK REARWARD
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 307
- When Monitored:
The Adjustable Pedals Switch is in active operation.
- Set Condition:
The Memory Seat Module detects that the Adjustable Pedals Switch has been activated for a time period of more than 50 seconds.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 308
1. CHECK FOR DTC B1D5D-ADJUSTABLE PEDAL SWITCH CIRCUIT STUCK REARWARD
NOTE: This DTC must be active for the results of this test to be valid.
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Cycle the ignition switch from off to on.
4. Cycle the Adjustable Pedals Switch forward and rearward.
5. With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any
chafed, pierced, pinched, or partially broken wires.
- Refer to the APS INTERMITTENT CONDITION TEST. See: Accessories and Optional Equipment/Pedal Positioning System/Testing and
Inspection
2. CHECK CONNECTOR/TERMINAL FOR DAMAGE
NOTE: Check all terminals for broken, bent, pushed out, or corroded terminals.
1. Turn the ignition off.
2. Inspect the Memory Seat Module harness connector, and the Lower Switch Bank harness connector.
Are the connectors/terminals damaged?
Yes
- Repair as necessary.
- Perform the APS VERIFICATION TEST. See: Verification Tests/APS Verification Test
No
- Go To 3
3. CHECK (Q103) ADJUSTABLE PEDALS SWITCH REARWARD CIRCUIT FOR A SHORT TO GROUND
1. Disconnect the Memory Seat Module C5 harness connector.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 309
2. Disconnect the Adjustable Pedals Switch harness connector.
3. Using a 12-volt test light connected to 12-volts, probe the (Q103) Adjustable Pedals Switch Rearward circuit at the Adjustable Pedals Switch
harness connector.
Does the test light illuminate brightly?
Yes
- Repair the (Q103) Adjustable Pedals Switch Rearward circuit for a short to ground.
- Perform the APS VERIFICATION TEST. See: Verification Tests/APS Verification Test
No
- Go To 4
4. CHECK ADJUSTABLE PEDALS SWITCH SHORTED
1. Measure the resistance between the (Q103) Adjustable Pedals Switch Rearward and (Q102) Adjustable Pedals Switch Forward terminals at
the Adjustable Pedals Switch.
Is the resistance below 5.0 ohms?
Yes
- Replace and reprogram the Memory Seat Module.
- Perform the APS VERIFICATION TEST. See: Verification Tests/APS Verification Test
No
- Replace the Adjustable Pedals Switch.
- Perform the APS VERIFICATION TEST. See: Verification Tests/APS Verification Test
