JEEP Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.
2018年8月11日星期六
B1D28-PASSENGER MIRROR MOTOR COMMON CONTROL CIRCUIT HIGH
B1D28
B1D28-PASSENGER MIRROR MOTOR COMMON CONTROL CIRCUIT HIGH
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 376
- When Monitored:
When the Mirror Common Driver Output is turned on.
- Set Condition:
If the Passenger Door Module senses voltage on the (P70) Passenger Mirror Common Driver circuit within 10 ms of turning on the Mirror
Common Driver Output.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 377
1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Operate the Mirror Switch in all directions several times.
4. Cycle the ignition from on to off 3 times.
5. Turn the ignition on.
6. With the scan tool, read DTCs.
Does the scan tool display: B1D28-PASSENGER MIRROR MOTOR COMMON CONTROL CIRCUIT HIGH?
Yes
- Go To 2
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors.
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.
2. TEST FOR A SHORTED OUTSIDE REARVIEW MIRROR
1. Turn the ignition off.
2. Disconnect the Passenger Outside Rearview Mirror connector.
3. Turn the ignition on.
4. With the scan tool, erase DTCs.
5. Operate the Mirror Switch in all directions several times.
6. Cycle the ignition from on to off 3 times.
7. Turn the ignition on.
8. With the scan tool, read DTCs.
Does the scan tool display: B1D28-PASSENGER MIRROR MOTOR COMMON CONTROL CIRCUIT HIGH?
Yes
- Go To 3
No
- Replace the Outside Rearview Mirror.
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.
3. CHECK THE (P70) PASSENGER MIRROR COMMON DRIVER CIRCUIT FOR A SHORT TO VOLTAGE
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L Page 378
1. Measure the voltage of the (P70) Passenger Mirror Common Driver circuit.
Is the voltage above 0.2 volt?
Yes
- Repair the (P70) Passenger Mirror Common Driver circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.
No
- Replace the Passenger Door Module.
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.