B1D24-DRIVER MIRROR HORIZONTAL MOTOR CONTROL CIRCUIT HIGH

B1D24
B1D24-DRIVER MIRROR HORIZONTAL MOTOR CONTROL CIRCUIT HIGH
- When Monitored:
When the Mirror Horizontal Driver Output is turned on.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L    Page 370
- Set Condition:
If the Driver Door Module senses voltage on the (P75) Driver Mirror Horizontal Driver circuit within 10 ms of turning on the Mirror
Horizontal Driver Output.
1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Operate the Mirror Switch in all directions several times.
4. Cycle the ignition from on to off 3 times.
5. Turn the ignition on.
6. With the scan tool, read DTCs.
Does the scan tool display: B1D24-DRIVER MIRROR HORIZONTAL MOTOR CONTROL CIRCUIT HIGH?
Yes
- Go To 2
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors.
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.
2. TEST FOR A SHORTED OUTSIDE REARVIEW MIRROR
1. Turn the ignition off.
2. Disconnect the Driver Outside Rearview Mirror connector.
3. Turn the ignition on.
4. With the scan tool, erase DTCs.
5. Operate the Mirror Switch in all directions several times.
6. Cycle the ignition from on to off 3 times.
7. Turn the ignition on.
8. With the scan tool, read DTCs.
Does the scan tool display: B1D24-DRIVER MIRROR HORIZONTAL MOTOR CONTROL CIRCUIT HIGH?
Yes
- Go To 3
No
- Replace the Outside Rearview Mirror.
2010 Jeep Truck Grand Cherokee SRT-8 V8-6.1L    Page 371
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.
3. CHECK THE (P75) DRIVER MIRROR HORIZONTAL DRIVER CIRCUIT FOR A SHORT TO VOLTAGE
1. Disconnect the Driver Door Module C2 connector.
2. Measure the voltage of the (P75) Driver Mirror Horizontal Driver circuit at the Driver Door Module C2 connector.
Is the voltage above 0.2 volt?
Yes
- Repair the (P75) Driver Mirror Horizontal Driver circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.
No
- Replace the Driver Door Module.
- Perform the BODY VERIFICATION TEST. See: Verification Tests/Body Verification Test.